7M Crank hall effect trigger setup

$180.00$490.00

7M hall effect crank trigger set ONLY

Clear
SKU: 7m_crank_kit Categories: , , Tags: , ,

Description

Convert your 7M to a hall effect sensor set with either a 12 tooth or 12-1 tooth setup. 36-2 is currently unavailable until it is tested on car.

Core charge:

Yes, you will be charged a refundable $200 deposit for your timing cover and crank gear and will send everything needed for your install.

No, you will send in your timing cover and crank gear and will be modified once it’s received.

 

Install:

Install crank gear (Be careful not to damage or bump any teeth on install)

Install timing belt

Install timing cover

Thread sensor in until it gently touches the crank gear, back sensor out 1.5-2 turns.

Tighten sensor nut to 15 ft-lbs.

Verify the sensor nut is flat or parallel to the timing cover, if not it may touch the crank pulley and possibly damage nut or sensor from heat. If needed tighten the nut until the nut is flat.

Wire the sensor to your computer or wiring harness. (Must verify wiring below)

 

Pin|Color|Assignment

1: Brown – 12v IGN switch or main relay

2: White – Output signal

3: Blue – Sensor ground

4: Black – Not used

Additional information

Weight 5 lbs
Dimensions 10 x 7 x 3 in

Reviews

There are no reviews yet.

Be the first to review “7M Crank hall effect trigger setup”

Your email address will not be published. Required fields are marked *